无机材料学报

• 研究论文 • 上一篇    下一篇

溶胶-凝胶法制备抗原子氧涂层及性质研究

罗仲宽; 刘剑洪; 田德余; 洪伟良; 汤少金; 朱瑞祥   

  1. 深圳大学化学与生物学系 深圳 518060
  • 收稿日期:2003-02-17 修回日期:2003-04-15 出版日期:2004-03-20 网络出版日期:2004-03-20

Preparation and Properties of Atomic Oxygen Protective Coating Through Sol-Gel Method

LUO Zhong-Kuan; LIU Jian-Hong; TIAN De-Yu; HONG Wei-Liang; TANG Shao-Jin; ZHU Rui-Xiang   

  1. Chemistry Department; Normal College; Shenzhen University; Shenzhen 518060; China
  • Received:2003-02-17 Revised:2003-04-15 Published:2004-03-20 Online:2004-03-20

摘要: 采用有机无机复合的溶胶-凝胶方法,合成了用于聚合物表面保护层的前驱溶液.采用旋转涂覆方法,将前驱溶液涂覆于聚酰亚胺基片上,制成了表面涂层.将所制得的相应涂层分别进行原子氧暴露试验,其表面形貌的变化通过扫描电镜观测.结果表明,在原子氧辐照下,无保护的聚酰亚胺表面已非常粗糙,与辐照前的光滑表面形成显著的对比.而涂覆有保护层的表面,原子氧辐照前后却没有变化.这表明使用这种有机无机复合的溶液涂层具有很好的抗原子氧能力.

关键词: 原子氧, 涂层, 低轨道空间, 溶胶-凝胶, 有机无机复合

Abstract: A coating of atomic oxygen resistant was obtained through the sol-gel method, and the precursors for
the coating were synthesized and analyzed. The precursor liquid was prepared by using methacryloxypropyltrimethoxysilane (MAPTMS) and
tetraethylorthosilicate (TEOS). IR spectra of different precursor liquids were compared, and the strength of Si-O bonds was discussed. The coatings
prepared from the precursor liquid were exposed on atomic oxygen in an amount of 5.4×1020/cm2. The results obtained demonstrate that
the amount of TEOS addition has greater effects on the strength. SEM experiment shows that they also possess the good performance on the atomic
AO exposed oxygen resistant. The SEM photos show nearly no change for the coatings prepared from the precursors with and without AO exposure,
but the substrate Kapton without protective coating eroded. The coating prepared from this kind of precursor can protect the polymer surface from atomic oxygen erosion, and can be used in the
spacecraft in LEO.

Key words: atomic oxygen, coating, low earth orbital, sol-gel, organic-inorganic hybrids

中图分类号: