高级检索
无机材料学报

无机材料学报

• 研究论文 • 上一篇    下一篇

强制脉冲 CVI沉积 C纤维表面涂层的工艺研究

周清1,2, 董绍明1, 张翔宇1, 丁玉生1,2, 黄政仁1, 江东亮1   

  1. 1. 中国科学院上海硅酸盐研究所, 上海 200050; 2. 中国科学院研究生院, 北京 100049
  • 收稿日期:2005-12-23 修回日期:2006-03-02 出版日期:2006-11-20 网络出版日期:2006-11-20

Carbon Fiber Surface Coating by Forced Pressure-pulsed CVI

ZHOU Qing 1,2, DONG Shao-Ming1, ZHANG Xiang-Yu1, DING Yu-Sheng 1,2, HUANG Zheng-Ren1, JIANG Dong-Liang1   

  1. 1. Shanghai Institute of Ceramics, Chinese Academy of Sciences,
    Shanghai 200050, China; 2. Graduate University of Chinese Academy of Sciences,
    Beijing 100049, China
  • Received:2005-12-23 Revised:2006-03-02 Published:2006-11-20 Online:2006-11-20

PDF (PC)

1712

被引次数

12

摘要： 以MTS/H2为前驱物, 采用强制脉冲CVI(FP-CVI)方法, 进行了在C纤维表面沉积SiC涂层的研究, 并探讨了其工艺过程. 结果表明, 在1000～1100℃和(5～25)kPa, 沉积得到的\beta-SiC具有明显的(111)面取向, 涂层均匀一致, 厚度可控. 在实验过程中, 随着单次驻留时间和脉冲次数的增加, 涂层厚度也随之增加, 涂层厚度与脉冲次数成非线性关系. 当脉冲次数为300时, C纤维表面沉积SiC层后其质量增加达到36.18%.

关键词: C纤维, SiC涂层, FP-CVI

Abstract: A SiC coating was derived from a gaseous methyltrichlorosilane (MTS)/H2 precursor by forced pressure-pulsed CVI (FP-CVI) process at low temperatures and reduced pressure. In the present experiment, the FP-CVI
process was studied, and the correlation between the coating thickness and the depositing conditions, i.e. the deposition temperature, the pressure, the deposition time per pulse and the pulse number was investigated. In 1000--1100℃and (5--25)kPa, the homogeneous β-SiC coating synthesized has (111) orientation. The coating thickness increases as the holding time per pulse and the pulse number increase. It shows a nonlinear behavior between the coating thickness and the pulse number. When the pulse number reaches 300 in all, the mass increment is 36.18% after coating on the carbon fiber.

Key words: carbon fiber, SiC coating, FP-CVI

中图分类号: