无机材料学报 ›› 2019, Vol. 34 ›› Issue (3): 315-320.DOI: 10.15541/jim20180288

• 研究论文 • 上一篇    下一篇

SnO的歧化反应对SnTe热电性能的优化

胡慧珊, 杨君友, 辛集武, 李思慧, 姜庆辉   

  1. 华中科技大学 材料科学与工程学院, 材料成型与模具技术国家重点实验室, 武汉 430074
  • 收稿日期:2018-06-28 修回日期:2018-09-11 出版日期:2019-03-20 网络出版日期:2019-02-26
  • 作者简介:胡慧珊(1994-), 女, 硕士研究生. E-mail: 1724125728@qq.com
  • 基金资助:
    国家自然科学基金(51811530307, 51772109, 51572098, 51632006);清华大学新型陶瓷与精细工艺国重实验室开放基金(KF201704) National Natural Science Foundation of China (51811530307, 51772109, 51572098, 51632006);Open Fund of State Key Laboratory of New Ceramics and Fine Processing, Tsinghua University(KF201704)

High Thermoelectric Performance of SnTe from the Disproportionation of SnO

HU Hui-Shan, YANG Jun-You, XIN Jin-Wu, LI Si-Hui, JIANG Qing-Hui   

  1. State key Laboratory of Materials Processing and Die & Mould Technology, School of Materials Science and Engineering, Huazhong University of Science and Technology, Wuhan 430074, China;
  • Received:2018-06-28 Revised:2018-09-11 Published:2019-03-20 Online:2019-02-26
  • About author:HU Hui-Shan. E-mail: 1724125728@qq.com

摘要:

PbTe基化合物是一种热电性能优良的中温区热电材料, 但铅的毒性限制了其广泛应用, 因此类似化合物SnTe引起了人们关注。但SnTe的载流子浓度较高和晶格热导率较大使其ZT值较低。本研究利用SnO歧化反应对SnTe热电性能实现了协同调控。热压烧结过程中SnO在500 ℃左右发生歧化反应生成Sn单质和单分散的SnO2颗粒, Sn单质作为自掺杂可以填充SnTe中的Sn空位, 导致载流子浓度降低: 相比于SnTe基体, SnTe-6mol%SnO样品在600 ℃下的电阻率从6.5增大到10.5μΩ•m, Seebeck系数从105增大到146μV•K-1。同时, 原位反应生成的SnO2第二相单分散于晶界处, 多尺度散射声子传播而降低晶格热导率, SnTe-6mol%SnO样品晶格热导率在600 ℃下仅为0.6W•m-1•K-1, 相比于基体下降了33%左右, 从而使SnTe体系的热电性能得到明显提高。最终, 当SnO加入量为6mol%时, 样品在600 ℃下的ZT值~1, 相比于基体提升了一倍左右。

 

关键词: SnTe, 歧化反应, 热电性能

Abstract:

PbTe-based compositions are considered as excellent thermoelectric materials for the mid-temperature. However, the toxicity of lead limits its wide application. SnTe compounds, an analogue of PbTe, has attracted much attention. However, its ultrahigh carrier concentration and the large lattice thermal conductivity leads to a low ZT value of SnTe. In this work,thethermoelectric performance of SnTe is synergistically enhanced by introduction of Sn and SnO2 from the disproportionation of SnO in the process of the hot press sintering. On the one hand, Sn can compensate the Sn vacancies and decrease the carrier concentration of SnTe, leading to a simultaneous enhancement on resistivity and the Seebeck coefficient. For instance, compared with the pristine SnTe, resistivity and the Seebeck coefficient increases from 6.5μΩ•m to 10.5μΩ•m and from 105μV•K-1 to 146μV•K-1,respectively, for the sample of SnTe-6mol% SnO at 873K. On the other hand, in-situ generated SnO2 nanoparticles are dispersedly distributed on the grain boundaries, leading to the multiscale phonon scattering and the reduced lattice thermal conductivity. The minimum lattice thermal conductivity value is 0.6 W•m-1•K-1 for the sample SnTe-6mol% SnO at 873K, which is ~33% reduction compared with that of the pristine SnTe. As a result, the maximum ZT value of 0.96 (~100% enhancement, compared with that of the pristine SnTe) at 873K is achieved for the sample SnTe-6mol% SnO.

Key words: SnTe, disproportionation, thermoelectric performance

中图分类号: