无机材料学报 ›› 2016, Vol. 31 ›› Issue (7): 731-738.DOI: 10.15541/jim20150567

• • 上一篇    下一篇

硫化物负载ZnO/ZnAl2O4复合空心球及其光催化还原CO2

张 丽1, 张秀秀1,2, 戴超华1, 欧阳杰1, 阎建辉1,2   

  1. (1. 湖南理工学院 化学化工学院, 岳阳 414006; 2. 湘潭大学 化工学院, 湘潭 411105)
  • 收稿日期:2015-11-17 修回日期:2016-01-04 出版日期:2016-07-20 网络出版日期:2016-06-22
  • 作者简介:张 丽(1974–), 女, 博士, 副教授. E-mail: hgx.zl@163.com
  • 基金资助:
    国家自然科学青年基金(21306041);国家自然科学基金(21271071);湖南省教育厅重点项目(15A076)

Photocatalytic Reduction of CO2 over Sulfied-Loaded ZnO/ZnAl2O4 Composite Hollow Sphere

ZHANG Li1, ZHANG Xiu-Xiu1, 2, DAI Chao-Hua1, OUYANG Jie1, YAN Jian-Hui1, 2   

  1. (1. School of Chemistry and Chemical Engineering, Hunan Institute of Science and Technology, Yueyang 414006, China; 2. College of Chemical Engineering, Xiang Tan University, Xiangtan 411105, China)
  • Received:2015-11-17 Revised:2016-01-04 Published:2016-07-20 Online:2016-06-22
  • About author:ZHANG Li. E-mail: hgx.zl@163.com
  • Supported by:
    National Natural Science Young Foundation of China(21306041);National Natural Science Foundation of China(21271071);Scientific Research Foundation of Hunan Provincial Education Department of China (15A076)

摘要:

采用一步水热法制备了ZnO/ZnAl2O4纳米复合物, 通过浸渍法负载CuS、CdS和Bi2S3对其进行修饰, 并在模拟太阳光照射下研究负载样品的光催化活性。用XRD、SEM、TEM、BET和FL等技术对所得样品进行表征, 以NaOH 和Na2SO3作为光催化还原二氧化碳过程的牺牲剂, 考察了硫化物种类及其负载量对ZnO/ZnAl2O4光催化还原活性的影响。结果表明, 负载CuS和CdS均可提高ZnO/ZnAl2O4光催化还原活性, 而负载Bi2S3却有所降低。当CuS负载量为1wt%时, 样品光催化还原活性最佳, 反应6 h后所得还原产物甲醇的生成量为8.21 mmol/gcat, 在相同条件下较原样提高了约3.2倍。对CuS/ZnO/ZnAl2O4的光催化机理进行了初步探讨。

关键词: ZnO/ZnAl2O4, 硫化物, 光催化还原CO2

Abstract:

ZnO/ZnAl2O4 nanocomposites were successfully synthetized by a facile one-pot hydrothermal process. CuS, CdS and Bi2S3 were loaded on the ZnO/ZnAl2O4 by an impregnation process to investigate their photocatalytic activities under simulated sunlight irradiation. The as-prepared samples were characterized by XRD, SEM, TEM, BET and FL techniques. Meanwhile, photocatalytic reduction of CO2 from water over the samples was explored using NaOH and Na2SO3 as sacrificial reagents. The effects of the type and the amount of sulfides on photocatalytic reduction efficiency were investigated. The results indicated that Bi2S3-loading lowered down the photocatalytic activity of ZnO/ZnAl2O4, while CuS or CdS loading enhanced the photocatalytic activity. After ZnO/ZnAl2O4 loaded with 1wt% CuS, the maximum yield of 8.21 mmol/gcat methanol within 6 h was obtained, which increased by up to 3.2 times as compared to ZnO/ZnAl2O4 under the same conditions. The photocatalytic mechanism of the as-prepared CuS/ZnO/ZnAl2O4 were preliminarily discussed.

Key words: ZnO/ZnAl2O4, sulfide, photocatalytic reduction of CO2

中图分类号: