共聚炭化法制备多孔炭材料及其电容性能研究

doi:10.3724/SP.J.1077.2013.12234

无机材料学报 ›› 2013, Vol. 28 ›› Issue (3): 267-272.DOI: 10.3724/SP.J.1077.2013.12234

共聚炭化法制备多孔炭材料及其电容性能研究

孙丽红, 刘洪波, 夏笑虹, 何月德

(湖南大学材料科学与工程学院, 长沙410082)

收稿日期:2012-04-14 修回日期:2012-09-02 出版日期:2013-03-20 网络出版日期:2013-02-20
作者简介:孙丽红(1986–), 女, 硕士研究生.
基金资助:
国家自然科学基金(50872032); 湖南大学国家级大学生创新创业训练计划项目(531107061064)

Preparation of Porous Carbon by Copolymerization for Electric Double-layer Capacitors

SUN Li-Hong, LIU Hong-Bo, XIA Xiao-Hong, HE Yue-De

(College of Materials Science and Engineering, Hunan University, Changsha 410082, China)

Received:2012-04-14 Revised:2012-09-02 Published:2013-03-20 Online:2013-02-20
About author:SUN Li-Hong.
Supported by:
National Natural Science Foundation of China (50872032); National College Students Innovative Training Program of Hunan (51107061064)

摘要/Abstract

摘要： 采用酚醛树脂(PF)为热稳定聚合物, 端环氧基的聚合物(QS)为热不稳定聚合物, 利用聚合物共聚炭化法制备多孔炭。经红外光谱分析及热重分析证实, 在酚醛树脂与QS的共聚固化物中, QS链段上的环氧基与酚醛树脂链段上的酚羟基发生反应生成醚键, QS接枝到酚醛树脂的链段上。BET比表面积、孔结构和电化学性能分析表明: 在共聚固化物PF/QS的炭化过程中, QS的热解逸出能起到造孔作用, 并随着QS用量的增加多孔炭的比表面积先增大后减小。QS加入量为15%的多孔炭具有最大的比表面积609.0 m²/g、总孔容0.28 cm³/g和微孔孔容0.22 cm³/g, 与聚合物共混炭化法相比, 在相同热不稳定聚合物加入量条件下, 多孔炭的比表面积和孔容都有所提高。该多孔炭电极在30wt% KOH电解液中的比电容达177.5 F/g, 具有良好的电容特性。

关键词: 酚醛树脂, 端环氧基聚合物, 聚合物共聚炭化, 多孔炭, 电容性能

Abstract: Porous carbons were prepared by chemical blending using phenolic resin (PF) and epoxy-terminated prepolymer (QS) as carbon precursor and thermally decomposable polymer, respectively. Chemical reaction of PF with QS was manifested by FT-IR spectra and a higher decomposition temperature of QS in TG curves. In the curing reaction, epoxy groups of QS reacts with the phenolic hydroxyl of PF to form ether linkage. The influences of the content of QS on specific surface area, pore structure and electrochemical performance were investigated. As the content of QS increases, the specific surface area, total pore volume and micropore volume increases firstly and then decreases, reaching the maximum value of 609.0 m²/g, 0.28 cm³/g and 0.22 cm³/g, respectively when w(QS)/w(PF)=15%. The performances of prepared samples are better than that of porous carbon prepared by polymer blend method at the same condition. When the porous carbon used as the electrodes in electric double layer capacitor (EDLC), a satisfied speci?c capacitance of 177.5 F/g in 30wt% KOH aqueous electrolytes is acquired and the capacitance maintenance achieves 78% when the current density increases to 20 mA/cm².

Key words: phenolic resin, epoxy-terminated prepolymer, chemical blending, porous carbon, electrochemical performance

中图分类号:

Q657

孙丽红, 刘洪波, 夏笑虹, 何月德. 共聚炭化法制备多孔炭材料及其电容性能研究[J]. 无机材料学报, 2013, 28(3): 267-272.

SUN Li-Hong, LIU Hong-Bo, XIA Xiao-Hong, HE Yue-De. Preparation of Porous Carbon by Copolymerization for Electric Double-layer Capacitors[J]. Journal of Inorganic Materials, 2013, 28(3): 267-272.

参考文献

[1] XU Bin, CHEN Yu-Feng, WEI Gang, et al. Activated carbon with high capacitance prepared by NaOH activationfor supercapacitors. Materials Chemistry and Physics, 2010, 124(1): 504–509.

[2] LI Jing, HUANG Ke-Long, LIU Ye-Xiang. Preparation and electrochemical characterization of an activated carbon material with high surface area for supercapacitor. Materials Science & Technology, 2009, 17(1): 1–4.

[3] JINTAWAT C, TAKUJI Y, SHO K, et al. Synthesis of monodisperse carbonaceous beads with ordered mesoporous structure. Carbon, 2009, 47(3): 929–932.

[4] LONG Dong-Hui, ZHANG Jie, YANG Jun-He. Preparation and microstructure control of carbon aerogels produced using m-cresol mediated Sol-Gel polymerization of phenol and furfural. New Carbon Materials, 2008, 23(2): 165–169.

[5] ZHANG Lin, LIU Hong-Bo, LI Bu-Guang, et al. Study on the performance of porous carbon prepared by carbonization polymer blends made of PF and PVB and for the EDLC. Carbon, 2005, 1: 7–13.

[6] TANAKA S, NISHIYAMA N, EGASHIRA Y, et al. Synthesis of ordered mesoporous carbons with channel structure from an organic- organic nanocomposite. Chem. Commun., 2005, 16: 2125–2127.

[7] KOSONEN H, VALKAMA S, NYKANEN A, et al. Functional porous structures based on the pyrolysis of cured templates of block copolymer and phenolic resin. Advanced Material, 2006, 18(4): 201–205.

[8] WANG Y X, TAN S H, JIANG D L, et al. Preparation of porous carbon derived from mixtures of furfuryl resin and glycol with controlled pore size distribution. Carbon, 2003, 41(11): 2065–2072.

[9] XIA Xiao-Hong, LIU Hong-Bo, HUANG Yan-Rui. Preparation of porous carbon by polymer blending of phenolic resin and adipic diacid. Journal of Inorganic Materials, 2011, 26(8): 857–862.

[10] HUANG Yong, CHEN Xiao-Feng, LIU Jun-Hong. Non-isothermal curing kinetics of phenolic resin/epoxy resin composite. Journal of Sichuan University of Science＆Engineering (Natural Science Edition1), 2009, 22(5): 73–75.

[11] PELL W G, CONWAY B E, MARINCIC N. Analysis of non-uniform charge/discharge and rate effects in porous carbon capacitors containing sub-opitimal electrolyte concentrations. Journal of Electroanalytical Chemistry, 2000, 49(1): 9–21.

[12] LIU C L, DONG W S, CAO G P, et al. Influence of KOH followed by oxidation pretreatment on the electrochemical performance of phenolic based activated carbon fibers. Journal of Electroanalytical Chemistry, 2007, 611(1): 225–231.

[1]	王义良, 艾云龙, 杨书伟, 梁炳亮, 郑振环, 欧阳晟, 何文, 陈卫华, 刘长虹, 张建军, 刘智勇. M₃O₄(M=FeCoCrMnMg)高熵氧化物粉体的简易制备及超电容性能研究[J]. 无机材料学报, 2021, 36(4): 425-430.
[2]	丁卓峰, 杨永强, 李在均. 组氨酸功能化碳点/石墨烯气凝胶的制备及超级电容器性能[J]. 无机材料学报, 2020, 35(10): 1130-1136.
[3]	何永钦, 李晓云, 张景贤, 李晓光. 原位裂解碳对氮化铝基微波衰减陶瓷性能的影响[J]. 无机材料学报, 2018, 33(4): 421-426.
[4]	余正发, 王旭珍, 侯亚男, 赵宗彬, 李芮, 邱介山. 熔盐法制备氮掺杂多孔炭及其催化脱硫性能[J]. 无机材料学报, 2017, 32(7): 770-776.
[5]	李金宏, 周岐雄, 米红宇, 李显, 李惠萍. 基于煤萃取物的类石墨状多孔炭的制备及其电容性能研究[J]. 无机材料学报, 2016, 31(1): 39-46.
[6]	易上琪, 刘洪波, 夏笑虹, 黄桂荣, 马倩, 陈玉喜. 石墨烯/炭气凝胶的制备及其结构与性能研究[J]. 无机材料学报, 2015, 30(7): 757-762.
[7]	赵春荣, 杨娟玉, 丁海洋, 卢世刚. 核壳结构SiC/SiO₂纳米线的低温合成与表征[J]. 无机材料学报, 2013, 28(9): 971-976.
[8]	刘奕, 赵玉亮, 高兆芬, 姜霞, 曾宇平. 石墨烯纳米片的简易合成及其超级电容性能研究[J]. 无机材料学报, 2013, 28(06): 611-615.
[9]	谢炜, 程海峰, 匡加才, 陈朝辉, 楚增勇, 龙春光. 热处理升温速率对中空多孔炭纤维介电常数的影响[J]. 无机材料学报, 2011, 26(9): 939-943.
[10]	夏笑虹, 刘洪波, 黄衍瑞, 杨丽, 石磊. 己二酸/酚醛树脂共聚炭化制备多孔炭材料及其电性能研究[J]. 无机材料学报, 2011, 26(8): 857-862.
[11]	徐顺建,乔冠军,王红洁,李涤尘,卢天健. 酚醛树脂聚合相分离热解制备介孔碳[J]. 无机材料学报, 2008, 23(5): 971-974.
[12]	韩鹏献,王成扬,时志强,吕嘉辉,秦军,姚国富. 水蒸汽活化树脂炭用做双电层电容器电极材料[J]. 无机材料学报, 2007, 22(6): 1046-1050.
[13]	卢斌,刘吉轩,朱华伟,焦羡贺. 微波加热合成SiC纳米线的研究[J]. 无机材料学报, 2007, 22(6): 1135-1138.
[14]	张自禄,卢嘉春,杨裕生. 以酚醛树脂为炭源的LiFePO₄性能改进研究[J]. 无机材料学报, 2007, 22(5): 864-868.
[15]	李强,李开喜,谷建宇,范慧,吕春祥. 电化学电容器复合电极材料铜氧化物/多孔炭的制备及电化学性[J]. 无机材料学报, 2007, 22(5): 894-900.

共聚炭化法制备多孔炭材料及其电容性能研究

Preparation of Porous Carbon by Copolymerization for Electric Double-layer Capacitors

RichHTML

PDF (PC)

可视化

被引次数

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 15

编辑推荐

Metrics

本文评价