[1] Afonso C R M, Bolfarini C, Botta Filho W J, et al. Spray forming of glass former Fe63Nb10Al4Si3B20 alloy. Mater. Sci. Eng. A, 2007, 449-451: 884-889.[2] Inoue A, Shen B L, Chang C T. Super-high strength of over 4000 MPa for Fe-based bulk glassy alloys in [(Fe1-xCox)0.75B0.2Si0.05]96Nb4 system. Acta Mater., 2004, 52(14): 4093-4099.[3] Inoue A, Shen B L. Soft magnctic bulk glassy Fe-B-Si-Nb alloys with high saturation magnetization above 1.5 T. Mater. Trans., 2002, 43(4): 766-769.[4] Inoue A. Stabilization of metallic supercooled liquid and bulk amorphous alloys. Acta Mater., 2000, 48(1): 279-306.[5] Pan J, Chen Q, Li N, et al. Formation of centimeter Fe-based bulk metallic glasses in low vacuum environment. J. Alloys Compd., 2008, 463(1/2): 246-249.[6] Herlach D M. Non-equilibrium solidification of undercooled metallic melts. Key Engineering Materials,1993, 81-83: 83-94. [7] Venkataraman S, Scudino S, Eckert J, et al. Nanocrystallization of gas atomized Cu47Ti33Zr11Ni8Si1 metallic glass. J. Mater. Res., 2006, 21(3): 597-607.[8] Dong W, Masuda S, Takagi K, et al. The development of mono-sized micro silicon particles for spherical solar cells by pulsated orifice ejection method. Mater. Sci. Forum, 2007, 534-536: 149-152.[9] Masuda S, Takagi T, Dong W, et al. Solidification behavior of falling germanium droplets produced by pulsated orifice ejection method. J. Cryst. Growth, 2008, 310(11): 2915-2922.[10] Miura A, Dong W, Fukue M, et al. Preparation of Fe-based monodisperse spherical particles with fully glassy phase. J. Alloys Compd., 2011, 509(18): 5581-5586.[11] Huang X M, Uda S, Tanabe H, et al. In situ observations of crystal growth of spherical Si single crystals. J. Cryst. Growth, 2007, 307(2): 341-347.[12] Paradis P F, Ishikawa T, Yoda S. Non-contact measurement of thermophysi-cal properties of niobium at high temperatures. J. Mater. Sci., 2001, 36(21): 5125-5130.[13] Ranz W E, Marshall W R. Evaporation from drops. Chem. Eng. Prog., 1952, 48(3): 141-144. |