石墨粒度对纸基摩擦材料摩擦磨损性能的影响

doi:10.3724/SP.J.1077.2011.00638

无机材料学报 ›› 2011, Vol. 26 ›› Issue (6): 638-642.DOI: 10.3724/SP.J.1077.2011.00638

石墨粒度对纸基摩擦材料摩擦磨损性能的影响

张翔, 李克智, 李贺军, 付业伟, 费杰, 李海亮

(西北工业大学凝固技术国家重点实验室, 西安710072)

收稿日期:2010-08-20 修回日期:2010-11-05 出版日期:2011-06-20 网络出版日期:2011-06-07
作者简介:张翔(1982-), 男, 博士研究生. E-mail: zx521com@126.com
基金资助:
凝固技术国家重点实验室(西北工业大学)博士后基金(08-BZ-2010); 陕西省重大科技创新项目(2008ZKC04-07)

Effect of Graphite Particle Size on Friction and Wear Performance of Paper-based Friction Material

ZHANG Xiang, LI Ke-Zhi, LI He-Jun, FU Ye-Wei, FEI Jie, LI Hai-Liang

(State Key Laboratory of Solidification Processing, Northwestern Polytechnical University, Xi’an 710072, China)

Received:2010-08-20 Revised:2010-11-05 Published:2011-06-20 Online:2011-06-07
Supported by:
Research Fund of the State Key Laboratory of Solidification Processing (NWPU)(08-BZ-2010); Shaanxi Grand Technology Innovation Foundation (2008ZKC04-07)

摘要/Abstract

摘要： 采用湿法工艺制备了4种不同石墨粒度的纸基摩擦材料, 利用惯量摩擦试验机研究了石墨粒度对摩擦力矩曲线和动、静摩擦系数及磨损率的影响; 并对不同压力和转速条件下动摩擦系数的变化趋势进行了研究. 利用扫描电子显微镜观察了磨损后纸基摩擦材料的表面形貌. 研究结果表明: 随着石墨粒度的减小, 制动时间增加, 摩擦力矩曲线中间部分趋于平直; 动、静摩擦系数减小, 磨损率降低. 同时, 动摩擦系数随着制动压力和转速的增加而减小. 循环制动过程中, 石墨粒度较小的试样制动稳定性较好. 随着石墨粒度的减小, 摩擦表面形成了润滑性能良好的固体润滑膜, 有利于提高材料的耐磨性能.

关键词: 纸基摩擦材料, 石墨粒度, 摩擦磨损性能

Abstract: Paper-based friction materials containing four different graphite particle sizes were prepared using the wet paper-making process. The effects of graphite particle size on friction performance such as friction torque curves, dynamic friction coefficient, static friction coefficient and wear rate were studied by using an inertia friction tester. Meanwhile, the sensitivity of friction coefficient to braking pressure and rotating speed was also investigated. Worn surfaces of samples were analyzed by using scanning electron microscope. The results show that with graphite particle size decreasing, braking time increases and torque curves become more stable, while friction coefficient and wear rate decrease. The dynamic friction coefficient declines as braking pressure and rotating speed increase. Samples with proper particle size exhibit more stable friction coefficient in the continuous braking process. Lubricating film is formed to lower wear rate in the worn surface as the graphite particles size decreases.

Key words: paper-based friction material, graphite particle size, friction and wear performance

中图分类号:

TB332

张翔, 李克智, 李贺军, 付业伟, 费杰, 李海亮. 石墨粒度对纸基摩擦材料摩擦磨损性能的影响[J]. 无机材料学报, 2011, 26(6): 638-642.

ZHANG Xiang, LI Ke-Zhi, LI He-Jun, FU Ye-Wei, FEI Jie, LI Hai-Liang. Effect of Graphite Particle Size on Friction and Wear Performance of Paper-based Friction Material[J]. Journal of Inorganic Materials, 2011, 26(6): 638-642.

参考文献

[1] Eguchi M, Yamamoto T. Shear characteristics of a boundary film for a paper-based wet friction material: friction and real contact area measurement. Tribol. Int., 2005, 38(3): 327-335.

[2] 李贺军, 费杰, 齐乐华, 等(LI He-Jun, et al). 孔隙率对碳纤维增强纸基摩擦材料摩擦磨损性能的影响. 无机材料学报(Journal of Inorganic Materials), 2007, 22(6): 1159-1164.

[3] Gao H, Barber G C, Chu H. Friction characteristics of a paper- based friction material. Int. J. Automot. Tech., 2002, 3(4): 171-176.

[4] Hattori Y, Kato T. Theory of frictional vibration in wet clutches considering poroelastic properties of paper-based facing. J. Tribol., 1996, 118(3): 520-526.

[5] Cho M H, Ju J, Kim S J, et al. Tribological properties of solid lubricants (graphite, Sb2S3, MoS2) for automotive brake friction materials. Wear, 2006, 260(7/8): 855-860.

[6] Chen B M, Bi Q L, Yang J, et al. Tribological properties of solid lubricants (graphite, h-BN) for Cu-based P/M friction composites. Tribol. Int., 2008, 41(12): 1145-1152.

[7] 费杰, 李贺军, 齐乐华, 等. 石墨含量对纸基摩擦材料摩擦磨损性能的影响. 摩擦学学报, 2007, 27(5): 451-455.

[8] 吕亚非, 马玉宁, 韩翎, 等. 石墨在半金属摩擦材料中的作用及其对摩擦性能的影响. 北京化工大学学报, 2006, 33(5): 58-61.

[9] Kolluri D, Ghosh K A, Bijwe J. Analysis of load-speed sensitivity of friction composites based on various synthetic graphites. Wear, 2009, 266(1/2): 266-274.

[10] Zhang M J, Liu Y B, Yang X H, et al. Effect of graphite particle size on wear property of graphite and Al2O3 reinforced AZ91D-0.8%Ce composites. T. Nonferr. Metal. Soc., 2008, 18(1): 273-277.

[11] Kolluri D K, Boidin X, Desplanques Y, et al. Effect of natural graphite particle size in friction materials on thermal localisation phenomenon during stop-braking. Wear, 2010, 268(11/12): 1472-1482.

[12] 付业伟, 李贺军, 李克智. 纸基摩擦材料绿色制备工艺与摩擦磨损性能研究. 摩擦学学报, 2004, 24(2): 172-176.

[13] Fei J, Li H J, Qi L H, et al. Carbon-fiber reinforced paper-based friction material: study on friction stability as a function of operating variables. J. Tribol., 2008, 130(4): 041605-1-7.

[14] Matsumoto T. The influence of paper-based friction material porosity on the performance of a wet clutch. SAE Technical Paper, 1994, 941032: 1-8.

石墨粒度对纸基摩擦材料摩擦磨损性能的影响

Effect of Graphite Particle Size on Friction and Wear Performance of Paper-based Friction Material

PDF (PC)

可视化

被引次数

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 6

编辑推荐

Metrics

本文评价

[1]	曹峻, 许俊华, 喻利花. TiN/VCN多层膜的力学性能及摩擦磨损性能研究[J]. 无机材料学报, 2013, 28(2): 195-200.
[2]	周海军, 董绍明, 何平, 胡建宝, 吴斌. 碳/碳-碳化硅复合材料的摩擦磨损行为与机理[J]. 无机材料学报, 2013, 28(10): 1057-1061.
[3]	费杰,李贺军,付业伟,齐乐华,张雨雷. 连续制动条件下碳纤维增强纸基摩擦材料摩擦磨损性能研究[J]. 无机材料学报, 2010, 25(4): 344-348.
[4]	李贺军,费杰,齐乐华,付业伟,李新涛,王鹏云. 孔隙率对碳纤维增强纸基摩擦材料摩擦磨损性能的影响[J]. 无机材料学报, 2007, 22(6): 1159-1164.
[5]	范尚武,徐永东,张立同,成来飞,楼建军. C/SiC摩擦材料的制备及摩擦磨损性能[J]. 无机材料学报, 2006, 21(4): 927-934.
[6]	程先华,薛玉君,谢超英. 稀土改性玻璃纤维对PTFE复合材料摩擦磨损性能的影响[J]. 无机材料学报, 2002, 17(6): 1321-1326.