陶瓷材料压痕韧性的统计性质

无机材料学报

陶瓷材料压痕韧性的统计性质

龚江宏; 关振铎

新型陶瓷与精细工艺国家重点实验室清华大学材料科学与工程系, 北京 100084

收稿日期:2000-12-25 修回日期:2001-02-26 出版日期:2002-01-20 网络出版日期:2002-01-20

Statistical Properties of Indentation Toughness of Ceramics

GONG Jiang-Hong; GUAN Zhen-Duo

State Key Laboratory of New Ceramics and Fine Processing; Department of Materials Science and Engi-neering; Tsinghua University; Beijing 100084; China

Received:2000-12-25 Revised:2001-02-26 Published:2002-01-20 Online:2002-01-20

摘要/Abstract

摘要： 采用直接压痕法测定了钠钙硅酸盐玻璃和一种ＴｉＣ颗粒增强Ａｌ_２Ｏ_３复合材料的断裂韧性．研究表明，在同一压痕压制荷载下测得的同一种材料的压痕韧性呈现出较大离散性，可以采用Ｗｅｉｂｕｌｌ分布加以较好地描述．对两种材料的试验数据的对比分析指出，压痕韧性测试值的离散性反映了材料显微结构的不均匀性对材料局部裂纹扩展阻力的影响．基于这一分析，本文建议采用直接压痕法测定材料断裂韧性时，应尽可能增大试验量，从而对压痕韧性测试结果的统计性质作出完整描述．

关键词: 压痕, 断裂韧性, Weibull分布, 钠钙硅酸盐玻璃, 氧化铝

Abstract: The toughnesses of a soda-lime glass and a TiC particulate-reinforced alumina composite were measured by the direct indentation method. It
was found that, for each material, the indentation toughness measured at a given applied indentation load exhibits a large scatter and can
be described well with Weibull distribution function. Comparison between the experimental data obtained with different materials revealed that
the scatter in the measured indentation toughness can be attributed to the effect of microstructural inhomogeneity on the local crack resistance. Based on these findings, it was suggested that, when
determining the fracture toughness with the direct indentation method for a given material, a large number of individual measurements should
be made at a given indentation load to obtain a complete description for the statistical properties of the measured indentation toughness.

Key words: indentation, fracture toughness, Weibull distribution, soda-lime glass, alumina

中图分类号:

TB301

龚江宏,关振铎. 陶瓷材料压痕韧性的统计性质[J]. 无机材料学报.

GONG Jiang-Hong,GUAN Zhen-Duo. Statistical Properties of Indentation Toughness of Ceramics[J]. Journal of Inorganic Materials.

参考文献

[1] Palmqvist S. Jernkontorets Ann., 1957, 141: 303--307.
[2] Evans A G, Charles E A. J. Am. Ceram. Soc., 1976, 59: 371--372.
[3] Evans A G. In: Fracture Mechanics Applied to Brittle Materials. ASTM STP 678. American Society for Testing and Materials, 1979. 112--135.
[4] Anstis G R, Chantikul P, Lawn B R, et al. J. Am. Ceram. Soc., 1981, 64: 533--538.
[5] Niihara K, Morena R, Hasselman D P H. J. Mater. Sci. Lett., 1982, 1: 13--16.
[6] Shetty D K, Wright I G, Mincer P N, et al. J. Mater. Sci., 1985, 20: 1873--1882.
[7] Tanaka K. J. Mater. Sci., 1987, 22: 1501--1508.
[8] Laugier M T. J. Mater. Sci. Lett., 1987, 6: 355--356.
[9] Liang K M, Orange G, Fantozzi G. J. Mater. Sci., 1990, 25: 207--213.
[10] Matsumoto R L K. J. Am. Ceram. Soc., 1987, 70: C-366--C-368.
[11] Li Z, Ghosh A, Kobayashi A S, et al. J. Am. Ceram. Soc., 1989, 72: 904--911.
[12] Ponton C B, Rawlings R D. Mater. Sci. Technol., 1989, 5: 865--872.
[13] Glandous J C, Rouxl T, Qiu T. Ceram. Inter., 1991, 17: 129--135.
[14] Rizkalla A S, Jones D W, Miller R P. Brit. Ceram. Trans., 1996, 95: 250--253.
[15] Ray K K, Dutta A K. Brit. Ceram. Trans., 1999, 98: 165--171.
[16] Ritter J E, Mahoney F M, Jakus K. In: Fracture Mechanics of Ceramics 8. Plenum, 1986. 213--223.
[17] Franco A, Roberts S G, Warren P D. Acta Mater., 1997, 45: 1009--1015.
[18] Lawn B R, Fuller E R. J. Mater. Sci., 1975, 10: 2016--2024.
[19] Marshall D B. J. Am. Ceram. Soc., 1983, 66: 127--131.
[20] 赵喆, 龚江宏, 苗赫濯, 等(ZHAO Zhe, et al). 硅酸盐?学报(Journal of the Chinese Ceramic Society), 2000, 28: 371--375.
[21] Marshall D B, Noma T, Evans A G. J. Am. Ceram. Soc., 1982, 65: C-175--C-176.
[22] Weibull W. J. Appl. Mech., 1951, 18: 293--297.
[23] Khalili A, Kromp K. J. Mater. Sci., 1991, 26: 6741--6752.
[24] Cook R F, Pharr G M. J. Am. Ceram. Soc., 1990, 73: 787--817.
[25] Lawn B R, Evans A G, Marshall D B. J. Am. Ceram. Soc., 1980, 63: 574--581.
[26] Steinbrech R W. In: Fracture Mechanics of Ceramics 9. Plenum, 1992. 187--208.
[27] Evans A G. J. Am. Ceram. Soc., 1990, 73: 187--206.
[28] Becher P F. J. Am. Ceram. Soc., 1991, 74: 255--269.
[29] 金宗哲, 马眷荣, 汪林生(JIN Zong-Zhe, et al). 硅酸盐学报(Journal of the Chinese Ceramic Society), 1990, 18: 130--137.
[30] Bergman B. J. Mater. Sci. Lett., 1984, 3: 689--692.
[31] Davies D G S. Proc. Brit. Ceram. Soc., 1973, 22: 429--452.
[32] Quinn G D. J. Am. Ceram. Soc., 1990, 73: 2374--2384.
[33] Tennery V J, Breder K, Ferber M K, et al. J. Am. Ceram. Soc., 2000, 83: 1177--1785.